Hey everyone,
I have a aon 6000kv with the mini inferno,
i keep stripping the slipper gear! are the alloy gears any good?
Any cures for my problems
Thanks
Adrian
Hey everyone,
I have a aon 6000kv with the mini inferno,
i keep stripping the slipper gear! are the alloy gears any good?
Any cures for my problems
Thanks
Adrian
Is your slipper locked? Are you Using 3Racing gears? Whats causing your slipper to strip?
I was planing on getting alloy gears when I ran out of spurs, but Ive yet to strip any of them. On my stock spur I use the hard atomic slipper pad. with my 3racing spur I have a canter ball diff.
I was using delrin gears
I'm using a alloy pinion
And the rest of the drivetrain is standard
The slipper was locked too!
How bout your motor mount? The stock plastic mount softens up and flexs under a hot motor, alowing the pinion to come out of alignment and wear out the spur.
Also grains of sand getting between the gears will wear em out quickly too.
Lastly, too much play between gears will also wear them out.
Also, the center housing has a bit of a fault and you might want to get a 3Racing alloy one.
Has a fault in the centre housing?
What i noticed was, the standard centre gear diff gear from the centre shaft going to the back diff was at times seperating from the actual gear piece.
I wasn't too impressed haha!
Bookmarks