+ Reply to Thread
Results 1 to 3 of 3

Thread: brushless problems

  1. #1
    pllbz Guest

    Default brushless problems

    I'va got a mamba 5400 system and my friend has a 5400 mini rage...its virtually the same motor down to the green cans and mambe controller...recently my friends car started cogging really bad during start up and you have to barely pull the throttle to get it going. We tried replacing the wires with better gauge wire and we both have the same set-up, including batteries and pinion. Mine runs like a champ but his sucks the big one! i'm wondering if the cogging is a sign of a burnt out motor of is it something else????

  2. #2
    Turps Guest

    Default

    Could it be the batts he is using are reaching the end of there life?

  3. #3
    pllbz Guest

    Default

    no ...cuz we tried it on my car and it works...either the ESC or the motor

+ Reply to Thread

Similar Threads

  1. Brushless Vs. Brushed
    By groundhogg in forum Motors
    Replies: 15
    Last Post: 06-30-2006, 04:26 AM
  2. *Shopping list for brushless set-up*
    By Gronlund in forum Electronics
    Replies: 1
    Last Post: 05-15-2006, 11:51 PM
  3. Brushless Problems In A Half 8
    By hyper7racer in forum General Discussion
    Replies: 9
    Last Post: 01-23-2006, 10:01 AM
  4. Mild brushless set-up?
    By bcuzau in forum Brushless Motors
    Replies: 7
    Last Post: 11-11-2005, 06:14 AM
  5. Brushless Half8 for sale
    By TamiyaBF in forum General Discussion
    Replies: 9
    Last Post: 08-31-2005, 05:22 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts