+ Reply to Thread
Results 1 to 7 of 7

Thread: Clutch adjusting

  1. #1
    minijosh Guest

    Question Clutch adjusting

    I just wanted some info on adjusting my clutch. I'll be racing my truck on carpet with no jumps and when I hit the gas my clutch slips like its suppose to but I want to get rid of the lack of grip at the beginning. Will I make it tighter with that weird tool?

  2. #2
    bermbuster Guest

    Default

    you want to install a rubber washer like this:
    http://cgi.ebay.com/Mini-Inferno-Hal...QQcmdZViewItem
    Back in the states you can find a similar sized rubber washer in the plumbing aisle at home depot.
    The rubber gives more friction but under high stress will give.....

  3. #3
    minijosh Guest

    Default

    That's my new favorite store. I like the toyz. Thanks G.

  4. #4
    gazzer55 Guest

    Default

    Where does that rubber washer go? )inbetween the 2 gears on the slipper shaft)??

  5. #5
    Goad Guest

    Default

    Where would you put the washer

  6. #6
    davo Guest

    Default

    i know this is old but incase you are still wondering, it goes in between the 2 gears. but sence in cheep and don't like waiting around i cut 2 circles of duck tape and stick one to one gear and the other to the other gear and reinstulled with the washer and it is working good. a little too much grab because i have it too tight but i think once i get it diled in i will be very happy with the results

  7. #7
    davo Guest

    Default

    scratch that. turned out bad. i couldn't get it to losen up enough. it ws ether locked or compleatly loose.

+ Reply to Thread

Similar Threads

  1. Alum clutch shoe for the 09 ???
    By tdrinc1 in forum Kyosho Mini Inferno 09
    Replies: 1
    Last Post: 02-03-2008, 02:42 AM
  2. Question on the Atomic slipper clutch pads.
    By 46u in forum Parts and Hop-Ups
    Replies: 7
    Last Post: 10-01-2005, 02:52 PM
  3. Sliiping slipper clutch
    By liquidsky in forum General Discussion
    Replies: 32
    Last Post: 07-29-2005, 03:00 PM
  4. Slipper clutch question for brushless users
    By yellow in forum Brushless Motors
    Replies: 2
    Last Post: 07-04-2005, 04:56 PM
  5. Slipper clutch setting
    By OneTimeCRX in forum Setups
    Replies: 58
    Last Post: 04-18-2005, 08:51 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts