-
a few things I've noticed ( ball dif and drive cups)
so far my atomic center dif is doing just fine. it needs to be full tight but it is working.
I have 2 problems.
1) the steel drive cups I got are cutting the dog bones. maybe 15 minutes of use and the drive pins are 1/2 warn
2) my atomic spindles seem to have the bearing spacing just a touch too far apart. If I tighten up the wheel nut the bearing binds. only on one side. there is no room to put the kyosho FAQ spacer in either. that makes it worse.
I know the bearings are fully seated in the hub too.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
Forum Rules
Bookmarks