+ Reply to Thread
Results 1 to 7 of 7

Thread: I need some input for a receiver.

  1. #1
    bcuzau Guest

    Default I need some input for a receiver.

    Hi guys,

    which one should I choose for my JR xR3i?

    Hitec HFS03MM
    or
    GWS R6N II

    Is anyone using either receivers with a JR radio?

    -Nam

  2. #2
    bermbuster Guest

    Default

    I would go with the hi tec....
    I have a jrx3i radio and it works great.

  3. #3
    leapingbug Guest

    Default

    Id go with the hitec I never used either but i dont like the open connecter prongs on the GWS

  4. #4
    mat3833 Guest

    Default

    i use the novak xx-tra synthasized, it works great

    Matt

  5. #5
    NakedApe Guest

    Smile About the radio

    I just ordered a Quark 33A ESC and it says it has ABS braking.

    Can I use this facility with just any rx/tx combo or do I have to have a radio and receiver set that also has ABS like the Futaba Mega Tech 2PL??

    Also, will using FM instead of AM reduce EM interference from hi-power wire lines??

    Thanks,
    CR

  6. #6
    bermbuster Guest

    Default

    i believe the esc will pulse the brake signal.....giving you abs so it will work with any tx/rx. The Futaba pulses the signal to the rx making it work with all escs (quality of abs is dependent on esc)

  7. #7
    bcuzau Guest

    Default

    Quote Originally Posted by leapingbug
    Id go with the hitec I never used either but i dont like the open connecter prongs on the GWS
    Yeah I don't like the open prongs either.. I decided to get the GWS anyway just because it's a little smaller than the Hitec, and a lot smaller than my stock JR rx. I'll think of something to cover them up from each other and anything conductive.

    I hope it works well with my JR. Thanks guys.

    -Nam

+ Reply to Thread

Similar Threads

  1. Mini Inferno St Esc and Receiver HELP
    By thedamage in forum General Discussion
    Replies: 7
    Last Post: 10-01-2008, 03:03 AM
  2. Running stock servo with Aftermarket Receiver
    By Lord_Inferno in forum Electronics
    Replies: 0
    Last Post: 05-15-2007, 04:40 AM
  3. Will 3s li-po harm my servo or receiver?
    By pinoyboy in forum Electronics
    Replies: 0
    Last Post: 02-13-2007, 04:58 AM
  4. Tekin receiver?
    By Inferno454 in forum Electronics
    Replies: 1
    Last Post: 07-31-2005, 02:29 PM
  5. ESC, Receiver choice?
    By Inferno454 in forum Electronics
    Replies: 16
    Last Post: 07-18-2005, 02:43 PM

Bookmarks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts