...The AON 4900...Its a direct fit...I run my wires over the top to use the gap in the shell..I tried them around the side but they would hit...From the top is a mUCH better fit...
...HPI RS4 12t pinion...Lots to grab onto...There is a the TINIEST gap between the grub / set screw and the idler gear but it fits and goes round and round REALLY quickly
...Fits nicely into a 3Racing alloy mount...BIG gobs of room around the motor...I had to ENLARGEN the mounting holes from the front to let in a 3mm screw...Not a major hassle to make sure that there is between 3 & 4mm IN the motor...pretty easy really but just make sure to eye up your screw length BEFORE you start putting it in...Check your rotor revolves without problems...
...The 4900 runs off the MAMBA 25...Straight-forward and easy...If you can turn on a transmitter you can set up the MAMBA...The weight savings of a brushless ESC are HUGE over a brushed system...thats points FOR...
...The AON weighed in at 71 grams...Xspeed with 16 gauge wire and a Deans Ultra was 77 grams...Again points FOR...
...Running the AON on 6 cells I am getting slightly longer and more powerful runs than the Xspeed...speed is good and STILL controllable...I personally feel that I would rather be fast and on the edge than TOO fast...
...its probably more driving style but I now have to left off the gas earlier to take the turns i did with a brushed...Also the extra speed effects my chassis differently which I still havent gotten used to yet...This is my first brushless system...DEFINATELY wont be my last...
Bookmarks