...This is my 2000th post...To commerate I have started MY thread...I have been piggy-backing Ronny's for to long...Here is BitHed's Mini Inferno HalfEight buggy; very soon to become an ST...
CHASSIS
3mm Randel Stevens carbon chassis…
1mm carbon PanicToys STiffy™ top plate…
2mm carbon top plate…
STOCK arms: front / rear; top / bottom…
Randel Stevens 2mm carbon servo tray; modified…
3RACING rear lower brace; no torque rods at all…
DRIVETRAIN
AON 4900, attached to mount with two 3x8 titanium screws…
KYOSHO Alloy motor mount, attached with four 3x6 titanium screws…
Mamba 25 ESC: stock settings…
3RACING alloy center hub: STOCK center diff: no grease…
ATOMIC front / rear ball diffs done up VERY tightly, BOCA Ceramic Bearings, no grease
KYOSHO Titanium slipper shaft, locked with three Mini Inferno wheel bushings & tightened with 4mm alloy lock nut…
HPI 12t MiniZilla metal pinion…
STOCK gear cases front / rear…
ATOMIC BIG slipper gear. STOCK small slipper gear…
HPI stock cars wheels; 24mm, HPI Pirelli Rally tires, change to STOCK for ST?
CAW 1:10 conversion axle and hub set…
3RACING alloy rear hubs…
3RACING titanium center drive shafts…
#RACING titanium drive cups in ALL spots…
FIVESTAR heavy-duty alloy rear dog bones, change to 3R universals for the ST?
STOCK front dog bones, change to 3R universals for the ST?
SUSPENSION
CAW alloy towers front / rear...
KYOSHO oil shocks front / rear: KYOSHO red caps: various red alloy attachments...
KYOSHO red springs front / rear...
BAD HORSIE black shock covers...
TAMIYA #300 front: 2 hole piston, TAMIYA #200 rear: 2 hole piston..
HPI 30 degree o-rings, smeared with AE Green Slime, no spacers…
KYOSHO rear stabilizer, soft spring, set loose…
STEERING
3RACING titanium steering posts, TAMIYA Titanium Grease on the posts, KYOSHO stock steering parts...
KYOSHO alloy front hubs: KYOSHO washers and screws TAMIYA Thread Locked...
STOCK 20 degree caster blocks...
HITEC 85MG servo, KYOSHO brace with the top cut off; change to full size HITEC HS-5625MG?
FIVESTAR 3mm carbon steering plate: brass bushings…
OTHER BITS
BOCA Bearings Ceramic Lightning Series throughout…
LUNSFORD titanium buckles…
3RACING titanium hinge pins…
FIVESTAR 3mm carbon hinge holders front / rear…
KYOSHO #WO136 hard balls x 10; fitted in all ball holes except top of front shocks…
TAMIYA Alloy Flourine 5mm balls in ALL spots, various KYOSHO cups…
RED alloy antenna holder; white KYOSHO Super-Bendy antenna tube
AE 18T 27mhz am RX, velcroed to chassis, change to NOVAK XXL 27mhz fm?
KO PROPO 27mhz EX-5 propo, foam wheel, change to FUTABA 3PM 27mhz fm?
UNITED RC battery packs…8 cells / 10 cells…
VARIOUS titanium screws throughout…
BODY
KYOSHO clear body; painted by PYROGRAPHIX
RED alloy body pins, zip-ties attached
SERIOUSLY beat up wing mount, no THROUGH-screw, posts chopped short but now glued until my ST arrives…
WEIGHT: 740 RTR, body w/o batteries...
Bookmarks