+ Post New Thread
Page 1 of 6 1 2 3 ... LastLast
Threads 1 to 20 of 101

Forum: Motors

Motors, tuning, arms, cans, magnets...

  1. Opinion ..... X-speed , speed 400 , rocket 400 , krytal 4 --- which one is better

    which motor have a better performance on mini inferno? :rolleyes:

    Started by letian, 08-04-2005 06:56 AM
    5 Pages
    1 2 3 ... 5
    • Replies: 48
    • Views: 6,848
    12-01-2005 01:42 AM Go to last post
  2. Mamba 8000kv tested!

    We ran the car in a indoor track in HongKong. Rather small track Run time about 15mins. Need to use RC18T pinion on the motor because the hole on the kyosho pinion is bigger. The motor got a little hot but was ok, we then added a heatsink.. We had a great time with the system. One more...

    Started by MonoTuning, 04-05-2005 03:35 PM
    5 Pages
    1 2 3 ... 5
    • Replies: 47
    • Views: 4,422
    05-01-2005 11:56 PM Go to last post
  3. Slow axx in the car or what?

    I think it`s a greate car! But even with the x-speed in it the acceleration is very slow! Anyone more then me that thinks so? The only thing i really imagined with the x-speed was that the car went a little faster, but not the fast that i thougt it would be... I`ll hope that the 8cell GP batteri...

    Started by chrille, 04-01-2005 08:49 PM
    5 Pages
    1 2 3 ... 5
    • Replies: 43
    • Views: 2,638
    04-08-2005 02:56 PM Go to last post
  4. LRP Fusion Micro Modified Motor (370-size)

    Guys are prayers have been answered..the perfect size and motor for our car! Check it out! The ultimate speed weapon for any Micro-size car! The LRP Fusion Micro Modified motor is a scaled down (370-size), full-blown LRP Fusion 4.1 Modified motor (540-size)!! The LRP Fusion Micro Modified...

    Started by WhoMe, 04-07-2005 06:16 AM
    5 Pages
    1 2 3 ... 5
    • Replies: 40
    • Views: 6,208
    09-28-2005 01:46 AM Go to last post
  5. motors?

    Is there Any company's that will have aftermarket motors out , or has any one annonced it?

    Started by mini-z racing, 03-16-2005 03:48 AM
    4 Pages
    1 2 3 ... 4
    • Replies: 38
    • Views: 3,431
    04-14-2005 12:30 PM Go to last post
  6. New motor tested! 400 Rocket

    I just tested my new motor from http://www.hobby-lobby.com/speed400.htm It is at the very bottom of the page and it is called the rocket. It is the same size as the stock motor with a slightly shorter can but it has a plastic endbell. It is a 4.8 volt motor so I expected some seriouse heat...

    Started by mOOsE, 04-19-2005 05:13 AM
    4 Pages
    1 2 3 ... 4
    • Replies: 36
    • Views: 4,159
    07-06-2005 12:01 AM Go to last post
  7. 480BB Tuningmotor (with Mod)

    Hello from Germany! I have put in a 480BB Motor into my Half8. I drive that Car with 7.2V Cellpacks and it is very fast and drives very very good! I have throw out many Things from the Chassis and put my own selfmate Things into it! Today my 9.6V Cellpack arrives! :cool:

    Started by Sinned, 07-06-2005 03:05 PM
    4 Pages
    1 2 3 ... 4
    • Replies: 36
    • Views: 4,316
    09-29-2005 11:51 PM Go to last post
  8. ***Wraith 7k Review***

    Hello fellow Mini Inferno'ers,(does that work? :p) Well I got my Wraith 7k motor today and ran it. But before I get to the review I would like to give a big thanks to Troy over at www.b-p-p.com. I've talked to him on the phone and he is a super cool and knowledgable guy. I was going over...

    Started by AkRacingProducts, 06-20-2006 05:13 AM
    4 Pages
    1 2 3 ... 4
    • Replies: 35
    • Views: 5,524
    02-06-2007 04:06 PM Go to last post
  9. Exclamation Hothothot

    ...ok...i have a theory that i needed to get out there before i started on it, plus i just needed to look like i was busy for about an hour ;) ...The motor is getting very hot...both brushed and brushless are getting very hot... ...this is what i think... ...The slipper is creating a...

    Started by BitHed, 04-23-2005 02:05 AM
    4 Pages
    1 2 3 ... 4
    • Replies: 32
    • Views: 3,487
    04-26-2005 04:03 PM Go to last post
  10. Any upgrades??

    I just upgrade my inferno with xspeed motor and bearings for the diff.I am running on 2S lipo and looks that the speed does indeed increase.Using the stock esc/rx unit can the xspeed take in 3s 11.4v lipo?Thanks.Anything which i could add in with low cost?

    Started by ofna, 12-26-2005 11:23 AM
    4 Pages
    1 2 3 ... 4
    • Replies: 31
    • Views: 2,500
    01-08-2006 02:55 AM Go to last post
  11. Mamba question

    Does anyone have a mamba 8000 on their h8? I hear that the h8 is super slow out of the box and it needs a better motor. I just wanted to know what people (who own the mamba) think about the performance. I would like to get my h8 around 35-40 mph. Can this be achieved with the mamba 8000 and maybe a...

    Started by nismo4life, 07-31-2005 07:46 AM
    3 Pages
    1 2 3
    • Replies: 21
    • Views: 2,590
    08-16-2005 01:06 AM Go to last post
  12. BAJA motor

    Has anyone tried this motor in there HALF8? I am currently running a Rocket400 with 7 Intellect cells but my pack starts getting a little "soft" at the 6 minute mark (7 minute mains). I used to run the BAJA motor in my mini-t and it was fast!.. but.. it is physically smaller than the...

    Started by DrVonHoSS, 12-29-2005 11:58 PM
    2 Pages
    1 2
    • Replies: 18
    • Views: 1,455
    01-17-2006 09:50 PM Go to last post
  13. Good motor?

    I have my half 8 on the way along with bearings, oil shocks and a rear carbon fiber shock mount. I like carbon fiber. The next thing I will get is a good 8-cell saddle battery pack and a better servo as well as more carbon fiber. Then I will want to get a good motor, which I am sure I will have...

    Started by 46u, 09-22-2005 07:02 PM
    2 Pages
    1 2
    • Replies: 17
    • Views: 1,640
    09-26-2005 02:13 PM Go to last post
  14. will the speed 480 motor fit

    i have fitted a speed 480 race motor in my rc18t.. it has crazy speed now,, almost comparable to he mamba 8000. since the mini inferno comes with a 400 can motor do you guys think there is enough room for the speed 480 motor,, ,, and this motor with 8 cells rocks,, im currently using...

    Started by jaejw1, 04-05-2005 09:52 PM
    2 Pages
    1 2
    • Replies: 16
    • Views: 2,177
    04-17-2005 02:20 PM Go to last post
  15. Pics of my Mamba 6800

    Here's a picture of my Mamba 6800 installed in the H8, loaded it down with LRP heatsinks and it doesn't get too hot at all. Very impressed wth this car so far :D ! I haven't got to run it much with the weather like it is down here in Southeast Louisiana, but it's given me the time to work on the...

    Started by EphiDelt490, 10-01-2005 04:23 PM
    2 Pages
    1 2
    • Replies: 15
    • Views: 1,859
    10-06-2005 08:14 PM Go to last post
  16. Brushless Vs. Brushed

    Is there a brushed motor made for the Mini Inferno that can keep up with the brushless selection out there? Lemme take a step back & explain my situation. I own an almost box stock MIST (new rec/speedo/motor/servo), that I like alot. I almost strictly race it, so I go for performance over bling....

    Started by groundhogg, 06-18-2006 09:33 PM
    2 Pages
    1 2
    • Replies: 15
    • Views: 1,961
    06-30-2006 04:26 AM Go to last post
  17. Breaking-in my X-Speed.

    I've found a very basic way to break in new motors. If you can run a new motor at 1/2-1/3 votlage for 20 to 30 minutes, it is a very basic way to seat new brushes to the comm. ;) My new X-Speed and a 6volt break-in setup.

    Started by Hammer, 07-18-2005 01:06 AM
    2 Pages
    1 2
    • Replies: 14
    • Views: 1,822
    10-24-2005 09:43 AM Go to last post
  18. HELP w/ motor/diff swap

    i want to move the motor to the other side of my st.....i know it can be done, i just need alittle more direction, maybe a cpl pics? thanks chris

    Started by garrettsdad, 06-22-2006 12:54 AM
    2 Pages
    1 2
    • Replies: 14
    • Views: 1,678
    08-20-2006 11:02 PM Go to last post
  19. After installed X-Speed Motor...

    and tightned the diff by one click, I found the car become nosier than before... Is that normal or I have messed up my installation? BTW, do you found that the "dial" (hex bolt) for diff. is very hard to turn? I did hold the big central gear steady with other hand.

    Started by hkopium, 04-08-2005 05:08 AM
    2 Pages
    1 2
    • Replies: 12
    • Views: 1,296
    04-09-2005 01:07 AM Go to last post
  20. Hi - New and confused

    Recentley got a mini Inferno ST. Had a lot of fun since I upgraded the battery to Kyosho 9.6v 1100Mah battery set but would love a bit more power. I was thinking of going for the X-Speed motor at first and see how I got on. Is there anything else that will give me more speed without going...

    Started by FLETCH, 02-26-2007 03:07 PM
    2 Pages
    1 2
    • Replies: 12
    • Views: 2,573
    05-20-2007 01:58 PM Go to last post

+ Post New Thread

Forum Information and Options

Moderators of this Forum

Thread Display Options

Use this control to limit the display of threads to those newer than the specified time frame.

Allows you to choose the data by which the thread list will be sorted.

Order threads in...

Note: when sorting by date, 'descending order' will show the newest results first.

Icon Legend

Contains unread posts
Contains unread posts
Contains no unread posts
Contains no unread posts
More than 15 replies or 150 views
Hot thread with unread posts
More than 15 replies or 150 views
Hot thread with no unread posts
Closed Thread
Thread is closed
Thread Contains a Message Written By You
You have posted in this thread

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts