View Full Version : Pinon Gear slipped out of the motor
trdcelica02
08-17-2005, 05:54 AM
I am running 8000 Mamba and the pinon slipped off the motor and grind the sliper gear....i tighten the pinion so tight and it slipped off when i was running it ...how can i fix this problem...
letian
08-17-2005, 03:27 PM
i had to grind it flat, then didn't slip out again :D
i had to grind it flat, then didn't slip out again :D
yes !! that is the only way to do it !! ;)
BitHed
08-21-2005, 11:52 AM
...yup...make a flat spot...btw you can use loctite or super glue too...either will melt / soften with a hot iron if you need to get them off...
Powered by vBulletin™ Version 4.0.6 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.