PDA

View Full Version : Tightening the servo saver?



BLACKHAWK444
06-21-2005, 01:42 AM
Well the servo saver is really loose stock. I want to tighten it. I tried ealier, but all I did was strip the screw on the bottom of the chassis that holds it. Does anyone have a good way to do this? Thanks.

akura2
06-21-2005, 03:40 AM
well all I did was grab that plastic adjusting ring on top of the saver and turn it clockwise.. now mine is nice and tight (but not too tight)...

Dono how you stripped the BOTTOM screw.... :confused:

BitHed
06-21-2005, 09:04 AM
...you COULD go with a bigger thread and loctite it...I actually snapped one of those metal 'wipers'...if its merely spinning around the screw try using the SAME screw but with loctite...I think you might find you might still be able to use it...its a nice idea to very LIGHTLY lube the wipers too...do NOT use mugen super but try the sexy smooth TAMIYA Titanium Grease...

BLACKHAWK444
06-21-2005, 11:41 AM
Ok. Well I tried to adjust the ring, but it won't budge and all I am doing to destroying the plastic. Maybe I will try again. I have some Tamiya Titanium grease coming in the mail, so I will try that also.