PDA

View Full Version : Mini inferno ST motor? Help me



jcarrer
09-04-2007, 06:36 PM
Helo, I am from Brasil and new in RC cars.
I have bad english write, SORRY.
I have a mini inferno ST RTR 1/16 by Kyosho.

Please, help me. I would like change the motor, better than, x-speed, by kyosho.
I read a lot this forum and I have a lot of doubts.

The doubts are:
which does motor is better for my Mini inferno, and is not necessary big changes?
It is necessary change servo and receiver, What these work for it?
I donīt know wath is mamba speed conttoler, it is necessary for it?

My motor have 2 wires and other motors have three wires, It is a problem? I do not know.
The servos its the same, my have three wires, and other have four, like Hitec 81 or 85MG. How can I do about this? There are a specifics for my mini inferno ST?
Please help me, what do I need for have a good speed RC car.

Thanks a lot.
Julio

Turps
09-13-2007, 07:28 AM
From what I have read if you wanna keep the std ESC/Rx then you need to use the std servo. But the motor can be upgraded.
I didnt have that opportunity as my ESC/RX died. So I just spent a small fortune and put in a brushless setup.