PDA

View Full Version : Hitec 85MG?



lukeita
05-06-2005, 01:48 PM
Hello!
I've just brought a miniservo at my LHS... but I don't know how to use in on my MiniInferno :) I changed the servo mount, choosing the one labeled "H", but I need two screws to connect my servo: which ones? Could you please post a photo if you've my same servo on your H8?
Thanks!!!

BitHed
05-06-2005, 02:49 PM
...Luca I used some hex 3x4 or 3x6, I think they were 3x6...You COULD use the 3x8 from the motor mount with some washers but 3x6 would be better...

...You dont HAVE to use the 2x6's which they show in the exploded view...Also they dont HAVE to be tapping screws, the ones that dif their own hole, you CAN use screws with the less aggressive thread...Hope this helps brotha :D I still have that coloured screw set you want too ;)

lukeita
05-06-2005, 05:17 PM
Hello
Thanks for your reply (you've new mail about screws :) )...
My problem is that I need looong screws... now I solved using strips (a trick I learned from 1/8 offroad...)

http://img237.echo.cx/img237/9425/servo13nh.jpg

http://img237.echo.cx/img237/1386/servo29hl.jpg

http://img237.echo.cx/img237/1354/servo33yz.jpg