PDA

View Full Version : 3R engine mount fan



Turps
02-16-2007, 10:41 PM
I just got a 3racing engine mount with the fan. Now since I understand I can run the RX off the same lead that is used for the ESC CH1. And the servo wire goes to CH2.
Would it work if I put the fan wire onto the Batt slot on the RX???
Also its a Futaba 2ch RX.

morati
02-16-2007, 10:48 PM
I just got a 3racing engine mount with the fan. Now since I understand I can run the RX off the same lead that is used for the ESC CH1. And the servo wire goes to CH2.
Would it work if I put the fan wire onto the Batt slot on the RX???
Also its a Futaba 2ch RX.
Fan goes to the BEC outlet
Remember this....1 to turn
2 to burn

minijosh
02-18-2007, 08:31 PM
I'm going to bypass the rx attachment and solder it straight to the batt leads. This way the fan runs when the batts are plugged in and switch for esc and be off or on. The wire from the fan is very short though so I'll have to find some more wire to solder. Is the fan a blower or extractor? I've not tried mine yet. I hope it's a blower.

Turps
02-18-2007, 11:39 PM
I cant remember but I did jam the wires into the batts to test it. And from memory it is a blower.