PDA

View Full Version : another motor test..



jaejw1
02-13-2007, 06:46 AM
vendetta truggy and buggy

well today i went to test out my home made cvd's for the truggy,, things went well.. until 45minutes before i had to leave.. i broke a front cvd... so i switched everything over to the buggy ...
ran the buggy with the gh4700 with the gearing set at 16/41 (6.48:1).. i thought something might have been wrong since it had no get up and go... then i noticed one of the rear wheels was barely on..
i screwed it in tightly and switched motors..

holy crap.. http://www.rcuvideos.com/view_video.php?vi...type=&category= (http://www.rcuvideos.com/view_video.php?viewkey=734fe93831e3fb400ce8&page=1&viewtype=&category=)

need i say more.. i have never seen the buggy run so strong with 16/41 gearing..
if you have seen the video witht he truggy.. the triple jump .. well this clears it every single damn time... and this is with the esc set on low.. the truggy wont do it unless the set up is right... but the buggy will overshoot it just the same way the truggy did with the mamba esc (setting on it was a lil high) ,,,

this motor is a winner for sure.. going to run it some more tomorrow and also test out my home made front cvd's.. and my 3racing wheels

jaejw1
02-20-2007, 03:35 PM
this is the permax 400/4d that i have in my vendetta now.. difference between the video and mine.. im using the half8th wheels and they are using stock and they are using a 3s lipo while i use a 2s lipo
they are using a 19/45 gearing while i use a 16/41 not much difference there..

but check this thing out.. i just wished they had used bigger wheels.. http://www.modellbau-schenk.de/LRP_Shark_Brushless.aspx

http://www.modellbau-schenk.de/videos/shark.avi