PDA

View Full Version : Wraith 7k Brushless and Mamba 25



SamHill
02-06-2007, 09:19 PM
Has anyone used this combination yet? I am wanting to delve into the Brushless world and not sure which setup would be best.
I drive on a fairly hard pack track that is on the smaller side.
Thought would be greatly appreciated.
Pete

sensoryoverload
02-11-2007, 04:44 AM
Use the Quark 33amp as I've melted two CC25 Mamba esc. I'm sure there's a couple of pic's some where on this forum. SO

jaejw1
02-11-2007, 02:32 PM
well I dont have a mini inferno,,, but I do have a vendetta with mini inferno wheels,,,,
I have run with great success the golden horizon 4700 with the mamba esc in my detta buggy with final drive at 5.99:1 ,,, but now im using a quark pro car in my vendetta ST truggy and the thing flies,,,, this esc is better than the mamba .. in terms of delivering your power to the ground

I have recently tested another motor which may interest you,, great planes 28-35-3900 ammo check towerhobbies I run this motor in my truggy, which uses MIST wheels by the way, with final drive at 5.46:1 and it is fast.... ofcourse im on a 10th scale offroad dirt track....

I did a review of this motor in this forum,,, if you have the time you should read it

BiGRoB21
02-12-2007, 01:08 AM
i used to use that setup in my mini inferno and it was stupid fast! i had to turn down the throtal epa for it to be driveable

jaejw1
02-12-2007, 03:15 AM
i used to use that setup in my mini inferno and it was stupid fast! i had to turn down the throtal epa for it to be driveable
which set up,, the wraith/mamba

SamHill
02-13-2007, 01:29 AM
Thanks for all the great feedback. I will be getting something soon and this definately helps.
Pete