View Full Version : New motor for Mini-Inferno...?
Sabben
05-31-2006, 01:07 PM
Hi!
www.rcmart.com/catalog/product_info.php cPath=144_621_838&products_id=18072
Would this motor work in the mini-inferno?? Will it work with the standard ESC??
MrUnlimited
05-31-2006, 02:03 PM
Link is not working and when you copy the link it cannot be found :mad:
Sabben
06-01-2006, 01:11 PM
http://www.rcmart.com/catalog/product_info.php?cPath=144_621_838&products_id=18072
This should work!
gulozgur
06-01-2006, 01:14 PM
http://www.rcmart.com/catalog/product_info.php?cPath=144_621_838&products_id=18072
or that one
http://www.rcmart.com/catalog/product_info.php?cPath=144_506_105&products_id=18072
AkRacingProducts
06-01-2006, 01:39 PM
I highly doubt that motor will work with the stock ESC. I know that can't work with a MINI LST ESC, and that ones way better than the stock KMI esc.
Sabben
06-01-2006, 08:17 PM
What do you think?
Should I buy this motor and an better ESC, or should i get a brushless motor and a brushless ESC??
OvaYaHead
06-01-2006, 08:26 PM
at $42 for a brushed motor you might as well just spend a little more and go brushless.
What do you think?
Should I buy this motor and an better ESC, or should i get a brushless motor and a brushless ESC??
Hi!
This is a little internal... Go to Small Size at Lilletorget in Oslo, and get the
Mamba BL speedcontrol and the Dynamite C4 brushless - either the 8000Kv or 9200Kv. Itīs all you ever need...and not expensive, considering the performance :eek: (Only: youīll need receiver and servo too ofcourse) I run this with original diffs - only lubricated with plenty of Tamiya Ceramic grease!
The metal plate in the slipper has been replaced with rubber O-rings instead. Set the gear mesh right (a piece of paper between) and off you go - major fun :D I have yet to destroy anything in the driveline with this set up. Only the concrete wall did that :o - remember; the brake distance equals the increased speed. :rolleyes:
Have fun! (To be frank, i didnīt have fun untill this setup...the MI handles too well!)
Powered by vBulletin™ Version 4.0.6 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.