PDA

View Full Version : Kyosho H8->Brushless,Servo,8cell



Sideshow
11-11-2005, 07:12 AM
Hey guys,


Im now selling my Mini Inferno with a Hacker Brushless system

It includes

Hacker Brushless Motor (Flatspot on motorshaft for pinion setscrew)
Hacker Brushless ESC - Deans connectors installed
HS-81MG Servo

3racing Oil shocks (2 hole pistons)
3Racing Alum rear carriers(Uninstalled)
3Racing Alum Steering blocks
3Racing Alum CVDs
3Racing Alum front shock tower
3Racing Alum rear shock tower
3Racing Bearing set
3Racing Alum front lower and Upper arms (Unistalled)
3Racing Alum rear arms (2 the same)

Kyosho Aluminum Motor Mount (Never ran)
Kyosho 8 cell Batt pack w/deans connector

All bearings cleaned one run ago
Drivetrain is very free...Left diff case screws on center a little loose to releve stress off of the bearings.
The Diffs are very smooth and I took care of the car
Body has some cooling holes (Sort of hack job)


NOTE:

No Pinion gear is included (2.3mm Motor shaft size)
One of rims is cracked, held together with shoe goo
Wing has had some good hits, still holding together fine though


This car is excellent and wasnt used too much, It spent 75% of its life inside and 25% outside...Never seen water

The brushless rips and will make the car go real real fast when geared right.


It includes servo,Motor, Esc just add your radio of choice and go.




With everything I would like 245 US shipped

Trades are a Xray M18T or somthing else I guess

Sideshow
11-11-2005, 07:14 AM
more pics of the half eight/ brushless