PDA

View Full Version : Walkera Brushless motor´s.



Thomas P
10-28-2005, 10:49 AM
Anyone tried this engines? i can buy ths kinda cheap(cheap...middle)Her @ my shop...Im going to test the 380 size, i think it have a good tourqe?..maybe a 540 to :D....

They have

180----3200Kv 2mm shaft 6-18v

380----3100Kv 2mm shaft 6-18v

380----3100Kv 2.3mm Shaft 6-18v

540----4700Kv 5mm shaft 6-16.8.

The ESC, seems to be realy killer ESC,

60A Brushless Speed Controller





Features





Low resistence

High rate PWM

Sixteen cells Max (with BEC disabled)

Programmable brake

Programmable low-voltage cutuoff

Programmable timing advance

Programmable PWM

Soft start ramp up

Runs motor in forward / reverse

Auto motor cutoff with reset

Safe power arming program ensures motor will not run accidentally after turn on

Low torque start

Auto shut down when signal is lost

Specification

Constant 60A -Current Max 80A-Current BEC 4A - PWM 8/16/32K-Li-poly Ni-Mh- Low-Voltage Cutoff
(Programmable) 2 - 5 cells 6-18 cells Programmable

halfeight0to60
10-29-2005, 05:26 PM
The only place I’ve heard the name walkera is in rc helis. It’s the much much cheaper brand that just copies the big names. From personal experience everything they make is pretty much really low end. I’ve heard plenty of horror stories with their lipoly packs. I don’t think I would waste the time or the money messing with it. Just get a mamba or aon and have more fun and less time figuring out why it doesn’t move.

Thomas P
10-30-2005, 05:05 AM
Allready own 3 Mamba sys, just thougt i would test this, but if you say so, i have to think it over again :)