PDA

View Full Version : 540 size motor use



Nitro-Maximus
10-22-2005, 05:44 AM
Is it possible to squeeze a 540 in this bad boy???

Any pics if so...

Thanks in advance

ianpog
10-22-2005, 06:26 AM
o i think it's not possible. i think it would be too large to fit in.

mOOsE
10-22-2005, 06:28 AM
not without rearanging the center diff so that the motor is in the rear. even though, a 540 will yield very poor runtimes on a gp1100 pack...you can't really use lipo as the amp pull will borderline the lipo's limits while driving

Thomas P
10-23-2005, 06:45 AM
Yes itīs posible to do his, BUT some smaller modifications will be needed :D .

As Mr:mOOsE said, engine must be placed back(front of right rearwheel,if you se the car from the back). A cut in bodie will be needed,a custom made Motormount, and i think GPs 2200 4/5 Sub-c cells will do the job good(im running those inmy 540 MRX/MiniQuake)

I have already change place, check this, a 540 will fit, and so will Bateries

http://galleriet.hobby-site.com/bilder/Mini%20Inferno/infernomodd95.JPG